Below is the list of questions that can help you to clear CADD Centre’s Facilitator Certification Program (FCP Exam).These are also helpful in self evaluation of your 3d modeling knowledge &  proficiency in Siemens UG NX.

Some of these questions are also found to be there in CCube Certifications.

 

 

     What is the difference between Fully Fixed and Fixed constraint?

     What is the advantage In grouping feature?

     With “Through Curve” command you can use more than two?

     What are two stiffening features In MX Sheet Metal?

     What is the use of Clearance Browser?

     What is the default angle it automatically snaps in Auxiliary view?

     List any basic three requirements for a surface contour operation.

     List any five Drill Processor Operation Subtypes.

     What Is the function of Automatic Detection?

     What are the steps involved in sketching process?

     Is it possible to edit a model that is non-associative with no model history.

     Using instance geometry is that possible to create a pedestal bearing?

     What is automatic detection?

     How can you create a surface at the intersection of two or more?

     Which command will taper only the bend region of sheetmetal part?

     List all the sketch constraints available in sketcher environment of NX.

     List all the sketch constraints available in assembly mode of NX.

     Explain break chip drilling.

     Explain NC Assistant.

     List the coordinate system that are used frequently for design and

     What is the use of Interred Constraints and Dimensions?

     Is it possible to make dimensions between two points curves of ###?

     What is the default standard followed in NX drafting application?

     List the alignment options available in NX that allow to control how the feature flows from one section to another

     What is the default formula in NX for sheetmetal design?

     Explain interpart modeling.

     What is synchronous modeling?

     How can you define speed and feed for an operation?

     What is teaching mode?

     What is the use of model depth in Cycle Parameters Dialog?

     What is the difference between fully Fixed and Fixed constraint?

     What is the shortcut key for sectioning the model in modeling mode?

     List three basic requirements for surface contour operation?

     How can you identify that sketch is fully constrained?

     Explain the function of Spine in swept command?

     What do you mean by continuity in NX?

     By Which command we can find volume of  a closed surface body?

     Explain peck drilling.

     What is the function of Optimized Feed Rate?

     What are the possible way of selecting blank in turning?

     Which command is used to convert existing mating conditions those that were created with the Pre-NX 6 Mating Conditions?

     Which command is used to find and activate a specific NX command that associated with one or more words or phrases?

     Which type of surface has a curvature and tangency alignment?

     Which option in Add Component Dialog box will automatically places components in various locations so that they do not overlap?

     Explain the function of Dwell.

     How can you set tolerance for dimension in drafting application?

     What is the use of WCS in NX Manufacturing application?

     What is the identification of over constrained geometry?

     How can you assign solid density to existing solid bodies?

     Which command will trim or split a solid body using a surface or face?

     Which command is used to create a solid or sheetmetal body by sweeping one or more sections along two or three guides?

     Which command is used to create a base feature in sheetmetal?

     Explain design in context of Assembly.

     What are three animation outputs given by Tool Path Visualization?